Version 5.8 219 October 2009
SIP User's Manual 3. Web-Based Management
¾ To configure Call Waiting:
1. Open the 'Caller Waiting' page (Configuration tab > Protocol Configuration menu >
Endpoint Settings submenu > Call Waiting page item).
Figure 3-172: Call Waiting Page
2. From the 'Call Waiting Configuration' drop-down list corresponding to the port you want
to configure for call waiting, select one of the following options:
• 'Enable': Enables call waiting for the specific port. When the device receives a call
on a busy endpoint (port), it responds with a 182 response (not with a 486 busy).
The device plays a call waiting indication signal. When hook-flash is detected by
the device, the device switches to the waiting call. The device that initiated the
waiting call plays a Call Waiting Ringback tone to the calling party after a 182
response is received.
• 'Disable': No call waiting for the specific port.
• Empty: Call waiting is determined according to the global parameter 'Enable Call
Waiting' (described in ''Configuring Supplementary Services'' on page 170).
3. Click the Submit button to save your changes.
4. To save the changes to flash memory, refer to ''Saving Configuration'' on page 237.
To Next Page
Loading...
Need help?
General
