SIP User's Manual 212 Document #: LTRT-12801
MP-500 MSBG
3.4.5.11 Endpoint Settings
The Endpoint Settings submenu allows you to configure analog (FXS/FXO) port-specific
parameters. This submenu includes the following page items:
îš„ Authentication (refer to ''Configuring Authentication'' on page 212)
îš„ Automatic Di
aling (refer to ''Configuring Automatic Dialing'' on page 213)
îš„ Calle
r Display Information (refer to ''Configuring Caller Display Information'' on page
214)
îš„ Call Fo
rward (refer to ''Configuring Call Forward'' on page 216)
îš„ Calle
r ID Permissions (refer to ''Configuring Caller ID Permissions'' on page 217)
îš„ Call Waiting (refer to ''
Configuring Call Waiting'' on page 218)
3.4.5.11.1 Configuring Authentication
The 'Authentication' page defines a user name and password for authenticating each
device port. Authentication is typically used for FXS interfaces, but can also be used for
FXO interfaces.
Notes:
• For configuring whether authentication is performed per port or for the
entire device, use the parameter AuthenticationMode. If authentication is
for the entire device, the configuration in this 'Authentication' page is
ignored.
• If either the user name or password fields are omitted, the port's phone
number (defined in Configuring the Trunk Group Table on page 220) and
global password (refer to the parameter Password) are used instead.
• You can also configure Authentication using the ini file table parameter
Authentication (refer to ''SIP Configuration Parameters'' on page 318).
To Next Page
Loading...
Need help?
General
