SIP User's Manual 286 Document #: LTRT-12801
MP-500 MSBG
5.6.3 Configuring SNMPv3 to Operate with Non-Configured SNMPv3
System
The procedure below describes how to configure SNMPv3 using the EMS.
¾ To configure the device to operate with SNMPv3 via EMS (to a non-
configured System):
1. In the MG Tree, select the required Region to which the device belongs, and then
right-click the device.
2. From the shortcut menu, point to Configuration, and then click Snmp Configuration;
the MG Information screen appears.
Figure 5-8: MG Information Window
3. Select the SNMPv3 option.
4. Configure the SNMPv3 fields, and then select the Update Media Gateway SNMP
Settings check box.
5. Click OK; the 'Results Table' window appears displaying the update progress.
6. Click Done when complete.
7. In the MGs List, double-click the device; the Tab bar appears.
8. Open the 'SNMPv3 Users' screen (Network Provisioning frame > SNMPv3 Users
tab).
9. Select the tabs arrow button, and then from the shortcut menu, choose Unit Value.
10. The 'SNMPv3 Users' table is refreshed with the values that you entered in Step 4.
11. Click the Save button; the EMS and the device are now synchronized.
To Next Page
Loading...
Need help?
General
