100 HD96-24-CC-TP User Manual
If you wish to move or reorder the channels simply hold on to the channel icon you wish to move until it wiggles, then drag it to the new position. Channels will
automatically move up and down to allow the selected channel to be dropped in its new position.
The same principles apply to the VCAs. The only dierence being only Inputs and Outputs can be assigned to VCAs.
Alternative way to assign VCA/POP groups
Pressing and holding down the SEL button of the desired group (VCA or POP) in the global assignable shortcuts area will take you to the Groups page and automatically
select that group to edit.
Note: If more than 16 channels are assigned to a POP or VCA group pressing the groups SEL button will page through all assigned channels on the surface. Again, these
can be fully reordered as desired.
Pressing the VCA SEL button will also show channels assigned to it and will page through the channels if more than 16 channels are assigned.
Setting up an Aux/Group mix
Setting up a mix
The control surface has 96 congurable aux busses each of which can be used as a Subgroup or as a Flexi-Aux to send to other auxes. All of these busses can also be set
up as mono, stereo or paired/linked together. 24 matrix outputs can also be accessed directly from input channels via level controls. Similarly, to the inputs and groups,
identication of mixes is by colour coding.
In the input channel there is a Sends page which allows the selected channel to be turned On, set to Pre-Fader, sent to any Aux or Matrix using the Absolute, Relative or
Pass-thru method. It can also be used to adjust the pan in stereo Aux or Matrices.
The overview displays in the GUI channel strip show the status of these busses, which are colour coordinated to match those in the sends section of the control surface.
Routing to master stereo outputs
The following shows you how to route audio. Before proceeding with this operation, make sure nothing is muted and master faders are up.
To send audio to the L/R Master Output do one of the following:
Select the channel and press the ST (stereo) button in the Main Bus section on the surface.
In the GUI select the channel you wish to adjust and navigate to the Cong page in the widget. Press the Stereo BUS button.
Manchino Multi Edit Page (Basic introduction)
The Manchino page allows you to select and edit any number of inputs or outputs at once in one very easy place. For example, all channels can easily be selected and
sent to the stereo bus. A selection of channels could be made Pre-Fader all at once in many aux sends with a few touches of the screen.
On the left side of the GUI there are two tabs which are for either inputs or outputs. Functions for inputs and outputs vary depending on the parameters associated
with them. For example, 48v can’t be added to an AUX master.
To select the inputs or outputs you wish to edit simple touch their associated button on screen, by pressing and holding on a channel or bus button all channels or
busses can be selected at once. Individual channels can be removed by tapping on them.
If you select a few dierent channels and wish to clear your selection, press and hold on one of the selected channels to clear all. If you select a couple of channels or
busses then wish to add all the rest of the channels or busses, press and hold on a new unselected channel or bus. This will then select all other items in that page.
To Next Page
Loading...
Need help?
General
