196 HD96-24-CC-TP User Manual
Once a channel has been pinned, by pressing the button above the LCD, that channel will not change until the pin has been removed. Once a channel is pinned the
rotary encoder can be used to select the channel to be pinned. This can be any input, output or VCA.
Remember last pin when turned on (found in preferences, general congiguration) allows you to remove a pin channel temporally and add the same pinned channel
back in the same position when set again. With this function o all pins will be reset when removed.
Flip Target
Flip target allows any channels send contribution to an aux or matrix to be pinned to the surface.
Flip Target is ideal, for example, if you would like to keep the level of a vocal microphone send fader level to a monitor speaker aux send to always have direct access to
control feedback.
Pin to selected output in preferences needs to be on if you wish to keep a channel pinned in ip when ip mode is turned o.
To remove a pinned channel in ip, turn the rotary control fully counterclockwise until the pin is removed.
To Next Page
Loading...
Need help?
General
