166 HD96-24-CC-TP User Manual
Item Control Function
8 Sidechain Gain Control Adjust the gain of the side chain by +- 30 dB.
9 Sidechain Frequency Control Set the sidechain frequency from 40 Hz to 10 kHz.
10 Sidechain BW Control Set the bandwidth of the sidechain EQ from 0.1 (tight) to 5 (wide).
11 Gain Reduction Meter 16 LEDs show gain reduction.
12 Active Button Turn the Stressor on. When in active audio will pass un-processed for comparison purposes.
13 Input Meter 16 x 2 LEDs, which show stereo input metering.
14 Output Meter 16 x 2 LEDs, which show stereo output metering.
Dual Band & Brickwall limiter.
The Dual Band and Brickwall limiters are designed to ensure the output level never exceeds a set limit. They can be used to protect loudspeakers or the output to an in
ear monitor system. The innovative dual band limiters allow the user to limit the low and high bands independently of each other.
Tip: Use the Dual Band limiter on a Stereo DJ feed or signal to protect the speaker system from independent High and Low peaks.
Item Control Function
1 Input and Low Band GR Meter 14 LEDs which show stereo input metering. 14 LEDs which show gain reduction (GR) of the Low Band.
2 Output and High Band GR Meter 14 LEDs which show stereo output metering. 14 LEDs which show gain reduction (GR) of the High Band.
3 Input Gain - Control Adjusts the input level to the limiter. -20 dB to 40 dB.
4 Threshold - Control Threshold controls the point at which the limiter begins responding to signal level.
5 Attack - Control Attack controls the speed at which dynamic processing begins.
6 Release - Control Release sets the recovery speed of the gain attenuation when the input drops below the threshold.
7 Crossover - Control Sets the frequency at which the two bands are split.
To Next Page
Loading...
Need help?
General
