257 HD96-24-CC-TP User Manual
Direct Output
The direct output section provides a way of leaving the surface via an I/O box or a multitrack recording system. It lets you take a signal directly out of a dened point in
the input channel’s signal path and route it a physical output (a physical connection via one of the I/O boxes).
The pick o point by default is set pre-processing ready for virtual sound-check use. It can be set post processing or post fader if required.
Note: The Direct Out Mute can only be un-muted if the direct out is patched.
Options - Processing Order
The processing order section in the options page of the conguration widget can change the position of the EQ, Insert or Dynamics in any order you like in the input
channel’s signal path by holding and dragging to the desired order.
It is also possible if the Insert icon is before the Fader icon to make a post fader insert by dragging the Insert after the fader.
Note: Gate always precedes compression in the DYN block, no matter how the processing order is set. Fader can only move before insert to create a post fader
insert point.
To Next Page
Loading...
Need help?
General
