Texas Instruments Voyage 200 User Manual

Data/Matrix Editor 533
To turn Auto-calculate off and on from the Data/Matrix Editor:
If
Auto-calculate = OFF and you make changes as described above, the header
definitions are not recalculated until you set
Auto-calculate = ON.
Note: You may want to set Auto-calculate = OFF to make changes without recalculating
each time, enter a definition such as c1=c2+c3 before you enter columns 2 and 3, or
override any errors in a definition until you can debug the error.
Using Shift and CumSum Functions in a Column
Using Shift and CumSum Functions in a Column Using Shift and CumSum Functions in a Column
Using Shift and CumSum Functions in a Column
Header
HeaderHeader
Header
When defining a column header, you can use the shift and cumSum functions as
described below. These descriptions differ slightly from the Technical Reference module.
This section describes how to use the functions in the Data/Matrix Editor. The Technical
Reference module gives a more general description for the Home screen or a program.
1. Press:
ƒ
9
– or –
8
F
2. Change Auto-Calculate to OFF or ON.
3. Press ¸ to close the dialog box.

Texas Instruments Voyage 200 Specifications

General

Type	Scientific
Form factor	Pocket
Product color	Blue
Display resolution	128 x 240 pixels