Configuring VLAN Stacking Configuring VLAN Stacking Services
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 35-11
Configuring SVLANs
SVLANs carry customer traffic and are not configurable or modifiable using standard VLAN commands.
The ethernet-service svlan command is used to create an SVLAN. This command provides parameters to
specify the type of SVLAN: svlan for customer traffic.For example, the following command creates a
customer SVLAN:
-> ethernet-service svlan 300
Similar to standard VLANs, the administrative and Spanning Tree status for the SVLAN is enabled by
default and the SVLAN ID is used as the default name. The ethernet-service svlan command also
provides parameters for changing any of these status values and the name. These are the same parameters
that are used to change these values for standard VLANs. For example, the following commands change
the administrative and Spanning Tree status and name for SVLAN 300:
-> ethernet-service svlan 300 disable
-> ethernet-service svlan 300 stp disable
-> ethernet-service svlan 300 name “Customer A”
To delete an SVLAN from the switch configuration, use the no form of the ethernet-service svlan
command. For example, to delete SVLAN 300 enter:
-> no ethernet-service svlan 300
Commands Used for ...
ethernet-service svlan Creating SVLANs to tunnel customer traffic.
ethernet-service service-name Creating a VLAN Stacking service and
associating the service with an SVLAN.
ethernet-service svlan nni Configuring a switch port as a VLAN Stacking
NNI port and associating the NNI port with an
SVLAN.
ethernet-service nni Configuring a vendor TPID and legacy Spanning
Tree support for an NNI port.
ethernet-service sap Creating a VLAN Stacking SAP and associates
the SAP with a VLAN Stacking service name.
ethernet-service sap uni Configuring a switch port as a VLAN Stacking
UNI port and associating the UNI port with a
VLAN Stacking SAP.
ethernet-service sap cvlan Specifying the type of customer traffic that is
accepted on SAP UNI ports.
ethernet-service sap-profile Configures traffic engineering attributes for
customer traffic that is accepted on SAP UNI
ports.
ethernet-service sap sap-profile Associates a VLAN Stacking SAP with a profile.
ethernet-service uni-profile Configures how protocol control frames are
processed on VLAN Stacking UNI ports.
ethernet-service uni uni-profile Associates a VLAN Stacking UNI port with a
profile.
To Next Page
Loading...
Need help?
General
