Configuring IPv6 Verifying the IPv6 Configuration
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 17-31
Verifying the IPv6 Configuration
A summary of the show commands used for verifying the IPv6 configuration is given here:
For more information about the displays that result from these commands, see the OmniSwitch AOS
Release 8 CLI Reference Guide.
show ipv6 redist Displays the route map redistribution configuration.
show ipv6 interface Displays the status and configuration of IPv6 interfaces.
show ipv6 tunnel configured Displays IPv6 configured tunnel information.
show ipv6 tunnel 6to4 Displays IPv6 6to4 tunnel information.
show ipv6 routes Displays the IPv6 Forwarding Table.
show ipv6 route-pref Displays the configured route preference of a router.
show ipv6 router database Displays a list of all routes (static and dynamic) that exist in the IPv6
router database.
show ipv6 prefixes Displays IPv6 subnet prefixes used in router advertisements.
show ipv6 neighbors Displays the IPv6 Neighbor Table.
show ipv6 ra-filter Displays the RA filter configuration for an IPv6 interface.
show ipv6 tcp listeners Displays statistics for IPv6 listener traffic.
show ipv6 tcp connections Displays statistics for IPv6 connection traffic.
show ipv6 icmp statistics Displays ICMP6 statistics.
show ipv6 pmtu table Displays the IPv6 Path MTU Table.
show ipv6 tcp connections Displays TCP Over IPv6 Connection Table. Contains information
about existing TCP connections between IPv6 endpoints.
show ipv6 tunnel 6to4 Displays the UDP Over IPv6 Listener Table. Contains information
about UDP/IPv6 endpoints.
show ipv6 information Displays IPv6 information.
show ipv6 emp-interface Displays the IPv6 EMP interface configuration.
show ipv6 emp-routes Displays the IPv6 routes targeted to EMP port/IPv6 EMP interface
configuration.
To Next Page
Loading...
Need help?
General
