Configuring Port Mapping Creating/Deleting a Port Mapping Session
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 32-4
Creating/Deleting a Port Mapping Session
Before port mapping can be used, it is necessary to create a port mapping session. The following
subsections describe how to create and delete a port mapping session with the port-mapping user-port
network-port and port-mapping command, respectively.
Creating a Port Mapping Session
To create a port mapping session either with the user ports, network ports, or both the user ports and
network ports, use the port-mapping user-port network-port command. For example, to create a port
mapping session 8 with a user port on slot 1 port 2 to port 5 and a network port on slot 2 port 3, enter:
-> port-mapping 8 user-port 1/2-5 network-port 2/3
You can create a port mapping session with link aggregate network ports. For example, to create a port
mapping session 3 with network ports of link aggregation group 7 to 9, enter:
-> port-mapping 3 network-port linkagg 7
-> port-mapping 3 network-port linkagg 8
-> port-mapping 3 network-port linkagg 9
You can specify all the ports of a slot to be assigned to a mapping session. For example, to create a port
mapping session 3 with all the ports of slot 1 as network ports, enter:
-> port-mapping 3 network-port slot 1
You can specify a range of ports to be assigned to a mapping session. For example, to create a port
mapping session 4 with ports 5 through 8 on slot 2 as user ports, enter:
-> port-mapping 4 user-port 2/5-8
Deleting a User/Network Port of a Session
To delete a user/network port of a port mapping session, use the no form of the port-mapping user-port
network-port command. For example, to delete a user port on slot 1 port 3 of a mapping session 8, enter:
-> no port-mapping 8 user-port 1/3
Similarly, to delete the network ports of link aggregation group 7 of a mapping session 4, enter:
-> no port-mapping 4 network-port linkagg 7
Deleting a Port Mapping Session
To delete a previously created mapping session, use the no form of the port-mapping command. For
example, to delete the port mapping session 6, enter:
-> no port-mapping 6
To Next Page
Loading...
Need help?
General
