Configuring QoS Using Condition Groups in Policies
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 26-59
Verifying Condition Group Configuration
To display information about condition groups, use the following show commands:
See the OmniSwitch AOS Release 8 CLI Reference Guide for more information about the syntax and
output for these commands.
show policy network group Displays information about all pending and applied policy network
groups or a particular network group. Use the applied keyword to
display information about applied groups only.
show policy service Displays information about all pending and applied policy services or a
particular policy service configured on the switch. Use the applied
keyword to display information about applied services only.
show policy service group Displays information about all pending and applied policy service
groups or a particular service group. Use the applied keyword to display
information about applied groups only.
show policy mac group Displays information about all pending and applied MAC groups or a
particular policy MAC group configured on the switch. Use the applied
keyword to display information about applied groups only.
show policy port group Displays information about all pending and applied policy port groups
or a particular port group. Use the applied keyword to display
information about applied groups only.
To Next Page
Loading...
Need help?
General
