Configuring 802.1AB Verifying 802.1AB Configuration
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 13-15
Verifying 802.1AB Configuration
To display information about the ports configured to handle 802.1AB, use the following show command:
For more information about the resulting display, see Chapter 16, “802.1AB Commands,” in the
OmniSwitch AOS Release 8 CLI Reference Guide.
show lldp system-statistics Displays system-wide statistics.
show lldp statistics Displays port statistics.
show lldp local-system Displays local system information.
show lldp local-port Displays port information.
show lldp local-management-address Displays the local management address information.
show lldp config Displays the general LLDP configuration information for
LLDP ports.
show lldp remote-system Displays local port information of remote system.
show lldp remote-system med Displays MED local port information of remote system.
show lldp remote-system application-tlv Displays Application Priority TLV information of the
remote system.
To Next Page
Loading...
Need help?
General
