Managing Authentication Servers Server Defaults
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 31-2
Server Defaults
The defaults for authentication server configuration on the switch are listed in the tables in the next
sections.
RADIUS Authentication Servers
Defaults for the aaa radius-server command are as follows:
* The port defaults are based on the older RADIUS standards; some servers are set up with port numbers
based on the newer standards (ports 1812 and 1813, respectively).
TACACS+ Authentication Servers
Defaults for the aaa tacacs+-server command are as follows:
LDAP Authentication Servers
Defaults for the aaa ldap-server command are as follows:
Description Keyword Default
Number of retries on the server before the
switch tries a backup server
retransmit 3
Timeout for server replies to authentication
requests
timeout 2
UDP destination port for authentication auth-port 1645*
UDP destination port for accounting acct-port 1646*
The port number for the server port 1812 (SSL
disabled)
2083 (SSL
enabled)
Whether a Secure Socket Layer is configured
for the server
ssl | no ssl no ssl
Description Keyword Default
Timeout for server replies to authentication
requests
timeout 2
The port number for the server port 49
Description Keyword Default
The port number for the server port 389 (SSL disabled)
636 (SSL enabled)
Number of retries on the server before the
switch tries a backup server
retransmit 3
To Next Page
Loading...
Need help?
General
