Using Switch Logging Switch Logging Commands Overview
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 36-5
Specifying the Severity Level
To specify the switch logging severity level, use the swlog appid command. The application ID can be
expressed by using either the ID number or the application ID CLI keyword as listed in the table
beginning on page 36-4. The severity level can be expressed by using either the severity level number or
the severity level type as shown in the table above. The following syntax assigns the “warning” severity
level (or 5) to the “system” application, (ID number 75) by using the severity level and application names.
-> swlog appid system level warning
The following command makes the same assignment by using the severity level and application numbers.
-> swlog appid 75 level 3
No confirmation message appears on the screen for either command.
Removing the Severity Level
To remove the switch logging severity level, enter the no swlog appid command, including the
application ID and severity level values. The following is a typical example:
-> no swlog appid 75 level 5
Or, alternatively, as:
-> no swlog appid system level warning
No confirmation message appears on the screen.
Specifying the Switch Logging Output Device
The swlog output command allows you to send the switch logging information to your console, to the
switch’s flash memory, or to a specified IP or IPv6 address(es).
Enabling/Disabling Switch Logging Output to the Console
To enable the switch logging output to the console, enter the following command:
-> swlog output console
To disable the switch logging output to the console, enter the following command:
-> no swlog output console
No confirmation message appears on the console screen for either command.
Enabling/Disabling Switch Logging Output to Flash Memory
To enable the switch logging output to flash memory, enter the following:
-> swlog output flash
To disable the switch logging output to flash memory, enter the following command:
-> no swlog output flash
No confirmation message appears on the screen for either command.
To Next Page
Loading...
Need help?
General
