Configuring IP Multicast Switching Modifying IPMS Parameters
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 25-19
-> no ip multicast router-timeout
You can also restore the IGMP router timeout on the specified VLAN or SPB service by entering:
-> ip multicast vlan 2 router-timeout 0
-> ip multicast service 10 router-timeout 0
Or, as an alternative, enter the following commands to restore the IGMP router timeout to its default
value:
-> no ip multicast vlan 2 router-timeout
-> no ip multicast service 10 router-timeout
Modifying the Source Timeout
The default source timeout (i.e., the expiry time of IP multicast sources) is 30 seconds. The following
subsections describe how to configure a user-specified source timeout value and restore it by using the ip
multicast source-timeout command.
Configuring the Source Timeout
You can modify the source timeout from 1 to 65535 seconds by entering ip multicast source-timeout
followed by the new value. For example, to set the source timeout to 360 seconds on the system if no
VLAN or SPB service is specified, you would enter:
-> ip multicast source-timeout 360
You can also modify the source timeout on the specified VLAN or SPB service by entering:
-> ip multicast vlan 2 source-timeout 360
-> ip multicast service 10 source-timeout 360
Restoring the Source Timeout
To restore the source timeout to its default value on the system if no VLAN or SPB service is specified,
use the ip multicast source-timeout command by entering:
-> ip multicast source-timeout 0
Or, as an alternative, enter the following command to restore the source timeout to its default value:
-> no ip multicast source-timeout
You can also restore the source timeout on the specified VLAN or SPB service by entering:
-> ip multicast vlan 2 source-timeout 0
-> ip multicast service 10 source-timeout 0
Or, as an alternative, enter the following command to restore the source timeout to its default value:
-> no ip multicast vlan 2 source-timeout
-> no ip multicast service 10 source-timeout
To Next Page
Loading...
Need help?
General
