Configuring QoS Creating Policies
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 26-52
-> policy rule r2 condition c1 action a1 default-list
Rules associated with the default policy list are applied only to ingress traffic, unless the rule is also
assigned to an egress policy list.
Verifying Policy Configuration
To view information about policy rules, conditions, and actions configured on the switch, use the
following commands:
show policy condition Displays information about all pending and applied policy conditions or
a particular policy condition configured on the switch. Use the applied
keyword to display information about applied conditions only.
show policy action Displays information about all pending and applied policy actions or a
particular policy action configured on the switch. Use the applied
keyword to display information about applied actions only.
show policy rule Displays information about all pending and applied policy rules or a
particular policy rule. Use the applied keyword to display information
about applied rules only.
show active policy rule Displays applied policy rules that are active (enabled) on the switch.
To Next Page
Loading...
Need help?
General
