Configuring High Availability VLANs High Availability Default Values
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 5-2
High Availability Default Values
The table below lists default values for high availability VLAN software.
Parameter Description Command Default Value/Comments
Server cluster admin state of the
server cluster
server-cluster admin-state - enable
Server cluster id and mode server-cluster mode - L2
Mac address of the server cluster server-cluster mac-address None
IP address of the server cluster server-cluster ip IP address is configurable only
for L3 clusters.
Configure the port/linkagg of a
server cluster
server-cluster port
server-cluster linkagg
None
To Next Page
Loading...
Need help?
General
