Configuring Access Guardian In This Chapter
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 28-2
In This Chapter
This chapter provides an overview of Access Guardian security features and describes how to configure
these features through the Command Line Interface (CLI). CLI commands are used in the configuration
examples; for more details about the syntax of commands, see the OmniSwitch AOS Release 8 CLI
Reference Guide.
The following information and procedures are included in this chapter:
• “Access Guardian Defaults” on page 28-3.
• “Quick Steps for Configuring Access Guardian” on page 28-10
• “Access Guardian Overview” on page 28-12.
• “Interaction With Other Features” on page 28-26.
• “Configuring Port-Based Network Access Control” on page 28-31.
• “Configuring UNP Profiles” on page 28-51.
• “Configuring UNP Classification Rules” on page 28-65.
• “OmniAccess Stellar AP Integration” on page 28-69.
• “Using Captive Portal Authentication” on page 28-76.
• “Using Guest Tunneling” on page 28-83.
• “Using Quarantine Manager and Remediation” on page 28-93.
• “Access Guardian Application Examples” on page 28-95.
• “Verifying Access Guardian Users” on page 28-109.
• “Verifying the Access Guardian Configuration” on page 28-114.
• “Bring Your Own Devices (BYOD) Overview” on page 28-115.
• “Multicast Domain Name System” on page 28-127.
• “Simple Service Discovery Protocol” on page 28-128.
• “Zero Configuration Networking (mDNS and SSDP)” on page 28-132.
• “BYOD Application Examples” on page 28-142.
For more information about configuring the UNP feature, see Chapter 28, “Configuring Access
Guardian,”
To Next Page
Loading...
Need help?
General
