Managing Source Learning Using Static MAC Addresses
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 3-4
Configuring Static MAC Addresses
To configure a permanent, bridging static MAC address, see the example below:
-> mac-learning vlan 1 port 1/1 static mac-address 00:00:02:CE:10:37 bridging
Use the no form of this command to clear MAC address entries from the table:
-> no mac-learning vlan 1 port 1/1 static mac-address 00:00:02:CE:10:37 bridging
To verify static MAC address configuration and other table entries, use the show mac-learning command.
For more information about this command, see the OmniSwitch AOS Release 8 CLI Reference Guide.
Static MAC Addresses on Link Aggregate Ports
Static MAC Addresses are not assigned to physical ports that belong to a link aggregate. Instead, they are
assigned to a link aggregate ID that represents a collection of physical ports. This ID is specified at the
time the link aggregate of ports is created.
To configure a static MAC address on a link aggregate ID 1 belong to VLAN 1 see the example below:
-> mac-learning vlan 1 linkagg 1 static mac-address 00:00:02:CE:10:37 bridging
For more information about configuring a link aggregate of ports, see Chapter 8, “Configuring Static Link
Aggregation” and Chapter 9, “Configuring Dynamic Link Aggregation.”
To Next Page
Loading...
Need help?
General
