Alcatel-Lucent OmniSwitch 6860 Series User Manual

Configuring QoS Creating Policies
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 26-43
ASCII-File-Only Syntax
When the policy rule, policy condition, and policy action commands as well as any of the condition
group commands are configured and saved in an ASCII file (typically through the snapshot command),
the commands included in the file include syntax indicating the origin of the command. The origin
specifies where the rule, condition, condition group, or action was created, either an LDAP server or the
CLI (from ldap or from cli). For built-in QoS objects, the syntax displays as from blt. For example:
-> policy action A2 from ldap disposition accept
The from option is configurable (for LDAP or CLI only) on the command line; however, it is not
recommended that a QoS object’s origin be modified. The blt keyword indicates built-in; this keyword
cannot be used on the command line. For information about built-in policies and QoS groups, see “How
Policies Are Used” on page 26-28.

Alcatel-Lucent OmniSwitch 6860 Series Specifications

General

Model	OmniSwitch 6860 Series
Category	Switch
Maximum Ports	48
Switching Capacity	Up to 176 Gbps
Operating System	AOS (Alcatel-Lucent Operating System)
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Relative Humidity	5% to 95% non-condensing
Port Types	10/100/1000BASE-T, SFP+, QSFP+
Ports	24, 48
Power over Ethernet (PoE)	Yes
Stacking	Yes
Operating Temperature	0°C to 50°C (32°F to 122°F)
Form Factor	1U rack-mountable
MAC Address Table Size	32, 000
Jumbo Frame Support	Yes
Dimensions (W x D x H)	440 mm x 420 mm x 44 mm (17.3 in x 16.5 in x 1.73 in)
Power Supply	AC or DC (depending on model)
Power Consumption	Varies by model and configuration