Configuring Ethernet Ports Interfaces Violation Recovery
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 1-16
Interface Violation Exceptions
An interface violation is not applied to an interface when any of the following scenarios occur:
• An interface is already in a permanent shutdown state. In this case, the only method for recovery is to
use the interfaces split-mode command.
• An interface is already shutdown by another feature.
• An interface is not operationally up.
Interaction With Other Features
The table below lists the features that use the interfaces violation recovery mechanisms, along with the
violation reason and shutdown type.
Feature Reason Code Shutdown Type
BPDU Shutdown STP Discard
User Port Shutdown QOS Discard
Policy rule - port disable QOS Discard
LPS LPS-D Discard
LPS LPS-S Admin-Down
UDLDUDLDAdmin-Down
NetSec NetSec Admin-Down
NI NISup Admin-Down
LLDP Rouge Detection LLDP Discard
Link Monitoring LinkMon Admin-Down
Link Fault Propagation LFP Admin-Down
Remote Fault Propagation RFP Admin-Down
To Next Page
Loading...
Need help?
General
