Configuring Spanning Tree Parameters In This Chapter
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 6-2
In This Chapter
This chapter provides an overview about how Spanning Tree works and how to configure Spanning Tree
parameters through the Command Line Interface (CLI). CLI commands are used in the configuration
examples; for more details about the syntax of commands, see the OmniSwitch AOS Release 8 CLI
Reference Guide.
Configuration procedures described in this chapter include:
• Selecting the Spanning Tree operating mode (flat or per-VLAN) on page 6-20.
• Configuring Spanning Tree bridge parameters on page 6-26.
• Configuring Spanning Tree port parameters on page 6-33.
• Configuring an example Spanning Tree topology on page 6-43.
To Next Page
Loading...
Need help?
General
