Version 6.2 103 February 2011
SIP User's Manual 3. Web-Based Management
¾ To enable an application:
1. Open the 'Applications Enabling' page (Configuration tab > VoIP menu >
Applications Enabling submenu > Applications Enabling).
Figure 3-67: Applications Enabling Page
2. Save the changes to the device's flash memory and then reset the device (see
''Saving Configuration'' on page 169).
3.3.2.5 Control Network
The Control Network submenu allows you to configure various SIP call control settings.
This menu contains the following page items:
îš„ IP Group Table (see Configuring IP Groups on page 103)
îš„ Proxy Sets Table (see
Configuring Proxy Sets Table on page 106)
3.3.2.5.1 Configuring IP Groups
The 'IP Group Table' page allows you to create up to nine logical IP entities called IP
Groups. An IP Group is an entity with a set of definitions such as a Proxy Set ID (see
''Configuring Proxy Sets Table'' on page 106),
which represents the IP address of the IP
Group.
IP Groups provide the following uses:
îš„ SIP dialog registration and authentication (digest user/password) of a specific IP
Group (Served IP Group, e.g., corporate IP-PBX) with another IP Group (Serving IP
Group, e.g., ITSP). This is configured in the 'Account' (see ''Configuring Account
Table'' on page 113).
îš„ Call routing rules:
• Outgoing IP calls (IP-to-IP or Tel-to-Tel): used to identify the source of the call
and used as the destination for the outgoing IP call (defined in the 'Tel to IP
Routing'). For Tel-to-IP calls, the IP Group (Serving IP Group) can be used as the
IP destination to where all SIP dialogs that are initiated from a Hunt Group are
sent (defined in ''Configuring Hunt Group Settings'' on page 126).
• Incoming IP calls (IP-to-IP or IP-to-Tel): used to identify the source of the IP call
• Number Manipulation rules to IP: used to associate the rule with a specific calls
identified by IP Group.
Notes:
• When operating with multiple IP Groups, the default Proxy server must
not be used (i.e., the parameter IsProxyUsed must be set to 0).
• You cannot modify IP Group index 0. This IP Group is set to default
values and is used by the device when IP Groups are not implemented.
• You can also configure the IP Groups table using the ini file table
parameter IPGroup (see SIP Configuration Parameters).
To Next Page
Loading...
Need help?
General
