AudioCodes MediaPack MP-124 User Manual

SIP User's Manual 456 Document #: LTRT-65415
MediaPack Series
Parameter Description
Web/EMS: RTP DSCP for MLPP
Flash Override
[MLPPFlashOverRTPDSCP]
Defines the RTP DSCP for MLPP Flash-Override precedence
call level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the global
parameter PremiumServiceClassMediaDiffServ or as defined for
IP Profiles per call (using the parameter IPProfile).
Web/EMS: RTP DSCP for MLPP
Flash-Override-Override
[MLPPFlashOverOverRTPDSCP]
Defines the RTP DSCP for MLPP Flash-Override-Override
precedence call level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the global
parameter PremiumServiceClassMediaDiffServ or as defined for
IP Profiles per call (using the parameter IPProfile).
10.12.6 Answer and Disconnect Supervision Parameters
The answer and disconnect supervision parameters are described in the table below.
Table 10-52: Answer and Disconnect Parameters
Parameter Description
Web: Answer Supervision
EMS: Enable Voice Detection
[EnableVoiceDetection]
Enables the sending of SIP 200 OK upon detection of
speech, fax, or modem.
 [1] Yes = The device sends a SIP 200 OK (in response
to an INVITE message) when speech, fax, or modem is
detected.
 [0] No = The device sends a SIP 200 OK only after it
completes dialing (default).
Typically, this feature is used only when early media
(enabled using the EnableEarlyMedia parameter) is used
to establish the voice path before the call is answered.
Notes:
 This feature is applicable only to one-stage dialing
(FXO).
 This parameter is applicable only to FXO interfaces.
Web/EMS: Max Call Duration (min)
[MaxCallDuration]
Defines the maximum call duration (in minutes). If this time
expires, both sides of the call are released (IP and Tel).
The valid range is 0 to 35,791. The default is 0 (i.e., no
limitation).
Web/EMS: Disconnect on Dial Tone
[DisconnectOnDialTone]
Determines whether the device disconnects a call when a
dial tone is detected from the PBX.
 [0] Disable = Call is not released (default).
 [1] Enable = Call is released if dial tone is detected on
the device's FXO port.
Notes:
 This parameter is applicable only to FXO interfaces.
 This option is in addition to the mechanism that
disconnects a call when either busy or reorder tones are
detected.

AudioCodes MediaPack MP-124 Specifications

General

Brand	AudioCodes
Model	MediaPack MP-124
Category	Gateway
Language	English