SIP User's Manual 452 Document #: LTRT-65415
MediaPack Series
Parameter Description
 HotLineToneDuration = if Hotline is enabled and the phone (connected
to the specific port) is off-hooked and no digit is pressed for this user-
defined duration (timeout), the device automatically initiates a call to the
user-defined destination phone number. The value range is 0 to 60
seconds, with default as 16. Note that you can use the "global"
HotLineToneDuration parameter to define this interval for all ports.
For example, the below configuration defines automatic dialing of phone
number 911 when the phone that is connected to Port 1 is off-hooked for
over 10 seconds:
TargetOfChannel 0 = 911, 1 ,10; (phone number "911" is automatically
dialed for Port 1after being off-hooked for 10 seconds)
Notes:
 This is parameter is applicable to FXS and FXO interfaces.
 The indexing of this ini file table parameter starts at 0.
 Define this parameter for each device port that implements Automatic
Dialing.
 This parameter can appear up to 8 times for MP-118-port and up to 24
times for MP-124 devices.
 After a ring signal is detected on an 'Enabled' FXO port, the device
initiates a call to the destination number without seizing the line. The
line is seized only after the call is answered. After a ring signal is
detected on a 'Disabled' or 'Hotline' FXO port, the device seizes the
line.
 For configuring this table using the Web interface, see ''Configuring
Automatic Dialing'' on page 154.
 For an explanation on using ini file table parameters, see ''Configuring
ini File Table Parameters'' on page 194.
10.12.5.11 Direct Inward Dialing Parameters
The Direct Inward Dialing (DID) parameters are described in the table below.
Table 10-50: DID Parameters
Parameter Description
Web/EMS: Enable DID
Wink
[EnableDIDWink]
Enables Direct Inward Dialing (DID) using Wink-Start signaling.
 [0] Disable = Disables DID Wink(default).
 [1] Enable = Enables DID Wink.
If enabled, the device can be used for connection to EIA/TIA-464B DID
Loop Start lines. Both FXO (detection) and FXS (generation) are
supported. An FXO interface dials DTMF digits after a Wink signal is
detected (instead of a Dial tone). An FXS interface generates the Wink
signal after the detection of off-hook (instead of playing a Dial tone).
Note: This parameter can also be configured per Tel Profile, using the
TelProfile parameter.
Web/EMS: Delay Before
DID Wink
[DelayBeforeDIDWink]
Defines the time interval (in msec) between detection of off-hook and
generation of a DID Wink.
The valid range is 0 to 1,000. The default value is 0.
Note: This parameters is applicable only to FXS interfaces.
To Next Page
Loading...
Need help?
General
