Version 6.2 327 February 2011
SIP User's Manual 9. VoIP Networking Capabilities
9.7.2.4 Troubleshooting the Routing Table
When adding a new static routing rule, the added rule passes a validation test. If errors are
found, the routing rule is rejected and is not added to the IP Routing table. Failed routing
validations may result in limited connectivity (or no connectivity) to the destinations
specified in the incorrect routing rule. For any error found in the Routing table or failure to
configure a routing rule, the device sends a notification message to the Syslog server
reporting the problem.
Common routing rule configuration errors may include the following:
îš„ The IP address specified in the "Gateway" column is unreachable from the interface
specified in the "Interface" column.
îš„ The same destination is defined in two different routing rules.
îš„ More than 30 routing rules were defined.
Note: If a routing rule is required to access OAMP applications (for remote
management, for instance) and this route is not configured correctly, the route
is not added and the device is not accessible remotely. To restore
connectivity, the device must be accessed locally from the OAMP subnet and
the required routes be configured.
To Next Page
Loading...
Need help?
General
