AudioCodes MediaPack MP-124 User Manual

SIP User's Manual 496 Document #: LTRT-65415
MediaPack Series
Parameter Description
''Configuring IP2IP Routing Table (SAS)'' on page 163.
 For a description on configuring ini file table parameters, see
''Configuring ini File Table Parameters'' on page 194.
10.14 Auxiliary and Configuration Files Parameters
This subsection describes the device's auxiliary and configuration files parameters.
10.14.1 Auxiliary/Configuration File Name Parameters
The configuration files (i.e., auxiliary files) can be loaded to the device using the Web
interface or a TFTP session (see ''Loading Auxiliary Files'' on page 170)
. For loading these
files using the ini file, you need to configure these files in the ini file and configured whether
they must be stored in the non-volatile memory. The table below lists the ini file parameters
associated with these auxiliary files. For a detailed description of the auxiliary files, see
''Auxiliary Configuration Files'' on page 217.
Table 10-63: Auxiliar
y and Configuration File Parameters
Parameter Description
General Parameters
[SetDefaultOnIniFileProcess]
Determines if all the device's parameters are set to their defaults
before processing the updated ini file.
 [0] Disable - parameters not included in the downloaded ini file
are not returned to default settings (i.e., retain their current
settings).
 [1] Enable (default)
Note: This parameter is applicable only for automatic HTTP update
or Web ini file upload (not applicable if the ini file is loaded using
BootP).
[SaveConfiguration]
Determines if the device's configuration (parameters and files) is
saved to flash (non-volatile memory).
 [0] = Configuration isn't saved to flash memory.
 [1] = Configuration is saved to flash memory (default).
Auxiliary and Configuration File Name Parameters
Web/EMS: Call Progress Tones
File
[CallProgressTonesFilename]
The name of the file containing the Call Progress Tones definitions.
Refer to the Product Reference Manual for additional information on
how to create and load this file.
Note: For this parameter to take effect, a device reset is required.
Web/EMS: Prerecorded Tones
File
[PrerecordedTonesFileName]
The name (and path) of the file containing the Prerecorded Tones.
Note: For this parameter to take effect, a device reset is required.
[UserInfoFileName]
The name (and path) of the file containing the User Information
data.

AudioCodes MediaPack MP-124 Specifications

General

Brand	AudioCodes
Model	MediaPack MP-124
Category	Gateway
Language	English