Version 6.2 333 February 2011
SIP User's Manual 10. Configuration Parameters Reference
10 Configuration Parameters Reference
The device's configuration parameters, default values, and their descriptions are
documented in this section.
Parameters and values enclosed in square brackets ([...]) represent the ini file parameters
and their enumeration values; parameters not enclosed in square brackets represent their
corresponding Web interface and/or EMS parameters.
Note: Some parameters are configurable only through the ini file.
10.1 Networking Parameters
This subsection describes the device's networking parameters.
10.1.1 Ethernet Parameters
The Ethernet parameters are described in the table below.
Table 10-1: Ethernet Parameters
Parameter Description
EMS: Physical Configuration
[EthernetPhyConfiguration]
Defines the Ethernet connection mode type.
 [0] = 10Base-T half-duplex (Not applicable)
 [1] = 10Base-T full-duplex
 [2] = 100Base-TX half-duplex
 [3] = 100Base-TX full-duplex
 [4] = Auto-negotiate (default)
For detailed information on Ethernet interface configuration, see
Ethernet Interface Configuration on page 311.
Not
e: For this parameter to take effect, a device reset is required.
Web: 802.1x Mode
EMS: Mode
[802.1xMode]
Enables support for IEEE 802.1x physical port security. The device
can function as an IEEE 802.1X supplicant. IEEE 802.1X is a
standard for port-level security on secure Ethernet switches; when a
unit is connected to a secure port, no traffic is allowed until the identity
of the unit is authenticated.
 [0] Disabled (default)
 [1] EAP-MD5 = Authentication is performed using a user name
and password configured by the parameters 802.1xUsername and
802.1xPassword.
 [2] Protected EAP = Authentication is performed using a user
name and password configured by the parameters
802.1xUsername and 802.1xPassword. In addition, the protocol
used is MSCHAPv2 over an encrypted TLS tunnel.
 [3] EAP-TLS = The device's certificate is used to establish a
mutually-authenticated TLS session with the Access Server. This
requires prior configuration of the server certificate and root CA
(see Configuring the Certificates on page 62). The p
arameter
802.1xUsername is used to identify the device, however
To Next Page
Loading...
Need help?
General
