SIP User's Manual 350 Document #: LTRT-65415
MediaPack Series
10.3.2 Syslog, CDR and Debug Parameters
The Syslog, CDR and debug parameters are described in the table below.
Table 10-14: Syslog, CDR and Debug Parameters
Parameter Description
Web: Enable Syslog
EMS: Syslog enable
[EnableSyslog]
Sends the logs and error message generated by the device to the
Syslog server.
 [0] Disable = Logs and errors are not sent to the Syslog server
(default).
 [1] Enable = Enables the Syslog server.
Notes:
 If you enable Syslog, you must enter an IP address of the Syslog
server (using the SyslogServerIP parameter).
 Syslog messages may increase the network traffic.
 To configure Syslog SIP message logging levels, use the
GwDebugLevel parameter.
 For information on the Syslog, refer to the Product Reference
Manual.
 By default, logs are also sent to the RS-232 serial port. For
information on establishing a serial communications link with the
device, refer to the Installation Manual.
Web/EMS: Syslog Server IP
Address
[SyslogServerIP]
The IP address (in dotted-decimal notation) of the computer on which
the Syslog server is running. The Syslog server is an application
designed to collect the logs and error messages generated by the
device.
Default IP address is 0.0.0.0.
For information on Syslog, refer to the Product Reference Manual.
Web: Syslog Server Port
EMS: Syslog Server Port
Number
[SyslogServerPort]
Defines the UDP port of the Syslog server.
The valid range is 0 to 65,535. The default port is 514.
For information on the Syslog, refer to the Product Reference Manual.
[MaxBundleSyslogLength]
The maximum size (in bytes) threshold of logged Syslog messages
bundled into a single UDP packet, after which they are sent to a Syslog
server.
The valid value range is 0 to 1220 (where 0 indicates that no bundling
occurs). The default is 1220.
Note: This parameter is applicable only if the GWDebugLevel
parameter is set to 7.
Web: CDR Server IP
Address
EMS: IP Address of CDR
Server
[CDRSyslogServerIP]
Defines the destination IP address to where CDR logs are sent.
The default value is a null string, which causes CDR messages to be
sent with all Syslog messages to the Syslog server.
Notes:
 The CDR messages are sent to UDP port 514 (default Syslog port).
 This mechanism is active only when Syslog is enabled (i.e., the
parameter EnableSyslog is set to 1).
To Next Page
Loading...
Need help?
General
