SIP User's Manual 74 Document #: LTRT-65415
MediaPack Series
Table 3-7: SNMP Community String Parameters Description
Parameter Description
Community String
 Read Only [SNMPReadOnlyCommunityString_x]: Up to five
read-only community strings (up to 19 characters each). The
default string is 'public'.
 Read / Write [SNMPReadWriteCommunityString_x]: Up to five
read / write community strings (up to 19 characters each). The
default string is 'private'.
Trap Community String
[SNMPTrapCommunityString]
Community string used in traps (up to 19 characters).
The default string is 'trapuser'.
3.3.1.6.6.2 Configuring SNMP Trap Destinations
The 'SNMP Trap Destinations' page allows you to configure up to five SNMP trap
managers.
¾ To configure SNMP trap destinations:
1. Open the 'SNMP Trap Destinations' page (Maintenance tab > System menu >
Management submenu > SNMP submenu > SNMP Trap Destinations).
Figure 3-46: SNMP Trap Destinations Page
2. Configure the SNMP trap managers parameters according to the table below.
3. Click the Submit button to save your changes.
4. To save the changes to flash memory, see ''Saving Configuration'' on page 169.
Note: Only table row entries whose corresponding check boxes are selected are
applied when clicking Submit; otherwise, settings revert to their defaults.
Table 3-8: SNMP Trap Destinations Parameters Description
Parameter Description
SNMP Manager
[SNMPManagerIsUsed_x]
Determines the validity of the parameters (IP address and
port number) of the corresponding SNMP Manager used
to receive SNMP traps.
 [0] (Check box cleared) = Disabled (default)
 [1] (Check box selected) = Enabled
To Next Page
Loading...
Need help?
General
