SIP User's Manual 70 Document #: LTRT-65415
MediaPack Series
3.3.1.6.3 Configuring Telnet and SSH Settings
The 'Telnet/SSH Settings' page is used to define Telnet and Secure Shell (SSH). For a
description of these parameters, see ''Web and Telnet Parameters'' on page 345.
¾ To define Telnet and SSH:
1. Open the 'Telnet/SSH Settings' page (Configuration tab > System menu >
Management submenu > Telnet/SSH Settings).
Figure 3-41: Telnet/SSH Settings Page
2. Configure the parameters as required.
3. Click the Submit button to save your changes.
4. To save the changes to flash memory, see ''Saving Configuration'' on page 169.
3.3.1.6.4 Configuring Web and Telnet Access List
The 'Web & Telnet Access List' page is used to define IP addresses (up to ten) that are
permitted to access the device's Web, Telnet, and SSH interfaces. Access from an
undefined IP address is denied. If no IP addresses are defined, this security feature is
inactive and the device can be accessed from any IP address. The Web and Telnet Access
List can also be defined using the ini file parameter WebAccessList_x (see ''Web and
Telnet Parameters'' on page 345).
¾ To add authorized IP addresses for Web, Telnet, and SSH interfaces access:
1. Open the 'Web & Telnet Access List' page (Configuration tab > System menu >
Management submenu > Web & Telnet Access List).
Figure 3-42: Web & Telnet Access List Page - Add New Entry
To Next Page
Loading...
Need help?
General
