EasyManuals Logo
Home>AudioCodes>Gateway>MediaPack MP-124

AudioCodes MediaPack MP-124 User Manual

AudioCodes MediaPack MP-124
504 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #113 background imageLoading...
Page #113 background image
Version 6.2 113 February 2011
SIP User's Manual 3. Web-Based Management
3.3.2.6.3 Configuring Account Table
The 'Account Table' page allows you to define up to 10 Accounts per Hunt Group (Served
Hunt Group) for registration and/or digest authentication (user name and password) to a
destination IP address (Serving IP Group). The Account table can be used, for example, to
register to an Internet Telephony Service Provider (ITSP) on behalf of an IP-PBX to which
the device is connected. The registrations are sent to the Proxy Set ID (see ''Configuring
Proxy Sets Table'' on page 106) a
ssociated with these Serving IP Groups.
A Hunt Group can register to more than one Serving IP Group (e.g., ITSP's). This can be
achieved by configuring multiple entries in the Account table with the same Served Hunt
Group, but with different Serving IP Groups, user name/password, host name, and contact
user values.
When using the Account table to register a Trunk Group (to a Proxy server), if all trunks
pertaining to the Trunk Group are down, the device un-registers the trunks. If any trunk
belonging to the Trunk Group is returned to service, the device registers them again. This
ensures, for example, that the Proxy does not send INVITEs to trunks that are out of
service.
Notes:
• For viewing Account registration status, see ''Viewing Registration
Status'' on page 189.
• You can also configure the Account table using the ini file table
parameter Account (see SIP Configuration Parameters).
¾ To configure Accounts:
1. Open the 'Account Table' page (Configuration tab > VoIP menu > SIP Definitions
submenu > Account Table).
Figure 3-72: Account Table Page
2. To add an Account, in the 'Add' field, enter the desired table row index, and then click
Add. A new row appears.
3. Configure the Account parameters according to the table below.
4. Click the Apply button to save your changes.
5. To save the changes, see ''Saving Configuration'' on page 169.
Note: For a description of the Web interface's table command buttons (e.g.,
Duplicate and Delete), see ''Working with Tables'' on page 39.

Table of Contents

Other manuals for AudioCodes MediaPack MP-124

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AudioCodes MediaPack MP-124 and is the answer not in the manual?

AudioCodes MediaPack MP-124 Specifications

General IconGeneral
BrandAudioCodes
ModelMediaPack MP-124
CategoryGateway
LanguageEnglish

Related product manuals