Version 6.2 45 February 2011
SIP User's Manual 3. Web-Based Management
To navigate between Scenario Steps, you can perform one of the following:
îš„ In the Navigation tree, click the required Scenario Step.
îš„ In an opened Scenario Step (i.e., page appears in the Work pane), use the following
navigation buttons:
• Next: opens the next Step listed in the Scenario.
• Previous: opens the previous Step listed in the Scenario.
Note: If you reset the device while in Scenario mode, after the device resets, you
are returned once again to the Scenario mode.
3.1.8.3 Editing a Scenario
You can modify a Scenario anytime by adding or removing Steps (i.e., pages) or
parameters, and changing the Scenario name and the Steps' names.
Note: Only users with access level of 'Security Administrator' can edit a Scenario.
¾
To edit a Scenario:
1. On the Navigation bar, click the Scenarios tab; a message box appears, requesting
you to confirm Scenario loading.
2. Click OK; the Scenario appears with its Steps in the Navigation tree.
3. Click the Edit Scenario button located at the bottom of the Navigation pane; the
'Scenario Name' and 'Step Name' fields appear.
4. You can perform the following edit operations:
• Add Steps:
a. On the Navigation bar, select the desired tab (i.e., Configuration or
Maintenance); the tab's menu appears in the Navigation tree.
b. In the Navigation tree, navigate to the desired page item; the corresponding
page opens in the Work pane.
c. In the page, select the required parameters, by marking their corresponding
check boxes.
d. Click Next.
To Next Page
Loading...
Need help?
General
