2. CNC Monitor Screen
2.7 Diagnosis
I - 206
2.7.9.5 Outputting the Data
Use either of
the followin
g screens to output the sampled data.
• CNC Data In/Out screen (Refer to "3. CNC Data Input/Output" in "III. MAINTENANCE")
(Example 1) Outputting data with CNC data input/output screen
(1) Select CNC for "Device" on top of the screen.
(2) Select "Mainte data" for "Directory".
(3) Select "NCSAMP.CSV".
(4) Press "Exec" to transfer the file.
(Example 2) Outputting data with the remote monitor tool
(1) Select [File] -> [Transfer] -> [Maintenance] from the menu bar to display the dialog box for
sending/receiving files.
(2) Designate "M01:\LOG\" for the directory.
(3) Designate the "NCSAMP.CSV" file.
(4) Press the "Receive" button. Then select the save destination.
(5) Pressing the "Save" button starts the file transfer.
(Note 1) Data cannot be output during the data sampling (when the <STATE> display is other than
"sampling stop" on the NC data sampling screen).
(Note 2) Changing the value of "#2 MARKS", "#4 CAPACITY" or "#31 PROCESS FORM", the output data
of which will be changed after the sampling has been completed, resets the sampling counter to "0".
The sampled data, if output after the change, will have the size 0.
To Next Page
Loading...
Need help?
General
