2. CNC Monitor Screen
2.2 Monitor
I - 32
2.2.4 Program Search
When the menu [SERCH] is pressed, the PROGRAM SEARCH screen is displayed.
The PROGRAM SEARCH screen enables you to call the program number, sequence number, and block
number for automatic operation from the machining programs registered in memory.
Display item Explanation
O12345678 N12345-12
The currently executing program number, sequence number, and
block number are displayed.
<SUB>
O 1000 N 200-30
When a subprogram is being executed, the program number,
sequence number, and block number of the subprogram are
displayed.
[PROGRAM FILE]
1 1111
100 12345678
111
888
1000
The numbers of the machining programs registered in memory are
listed.
The numbers ranging from 1 to 99999999 are displayed in the
ascending order.
If the number of the registered programs exceeds one page of
display, PROGRAM FILE is displayed extending across pages.
After MDI operation is executed, programs cannot be searched for unless reset is executed.
To restart from the middle of the program, search for the restart block, and then carry out MDI operation to
restore the modal state.
To Next Page
Loading...
Need help?
General
