Mitsubishi C70 User Manual

Appendix 6. Operation Messages on Setting Display Unit
Appendix 6.3 Dialog Error Messages on Input/Output Screen
IV - 34
Appendix 6.3 Dialog Error Messages on Input/Output Screen
The following error messages will appear if an illegal operation is carried out on the Data I/O screen.
Operations can be continued by pressing the "OK" button.
The error messages are listed below.
Function Target Error message Cause of error
NC SYSTEM NO. ILLEGAL The NC No. Mxx's xx is not within the designated
range.
DESIGNATED FILE NAME ALREADY EXIST The copy destination file already exists.
DIRECTRY ERROR The copy destination and copy source directories were
not found.
FILE NOT FOUND The copy source file was not found.
FILE NAME FORMAT ILLEGAL The file name format is illegal.
(The extension is wrong, etc.)
CAN'T READ OUT FILE The copy source file cannot be read.
CAN'T WRITE FILE The copy destination file cannot be written.
UNABLE TO COPY : PROGRAM RUNNING Automatic starting, MDI execution or history file
sampling is in progress.
UNABLE TO COPY : PLC RUNNING Cannot copy because the built-in PLC is running.
SOME ERROR FOUND IN FILE SYSTEM There is an error in the file system.
NO. OF REGISTRATION OVER The number of registerable programs was exceeded.
OUT OF MEMORY The storage capacity was exceeded.
DATA PROTECT The data is protected.
FILE NAME TOO LONG The file name is too long.
(Longer than 256 characters)
NC
Can't write file because other data in/out
function is accessing this NC. Please try
again later.
Another input/output function is being executed via the
network.
DESIGNATED FILE NAME ALREADY EXIST There is already a file in the PC.
DIRECTRY ERROR The directory was not found.
FILE NOT FOUND The file was not found.
CAN'T OPEN FILE Opening failed when reading files on PC.
CAN'T CREATE FILE Opening failed when writing files on PC.
TRANSFER ERROR : SOURCE FILE An error occurred when reading files from PC.
TRANSFER ERROR : DESTINATION FILE An error occurred when writing files to PC.
DRIVE NOT EXIST The designated drive was not found in the PC.
Copy
Memory
card
Can't read out file because other data in/out
function is accessing this NC. Please try
again later.
Another input/output function is being executed via the
network.

Mitsubishi C70 Specifications

General

Brand	Mitsubishi
Model	C70
Category	Control Unit
Language	English