1. Diameter
2. Pitch
GENERAL INFORMATION 0A-7
FASTENER INFORMATION
METRIC FASTENERS
Most of the fasteners used for this vehicle are metric fasteners.
When replacing any fasteners, it is most important that replacement
fasteners be the correct diameter, thread pitch and strength.
CAUTION:
Note that both ISO and JIS type bolts and nuts are used for
the engine assembly and related parts. Even when the diam-
eter of the thread is the same, its pitch may vary between
these two types. Installing a mismatched bolt or nut will
cause damage to the thread. As the first step, make sure to
tighten it by hand temporarily and if it feels tight, check the
thread pitch for correct matching.
To Next Page
Loading...
Need help?
General
