ENGINE COOLING 6B-9
ON-VEHICLE SERVICE
WARNING:
D Check to make sure that engine coolant temperature is
cold before removing any part of cooling system.
D Also be sure to disconnect negative cord from battery ter-
minal before removing any part.
COOLING SYSTEM DRAINING
1) Remove degassing tank cap.
2) Loosen drain plug (1) on radiator to drain coolant.
3) After draining coolant, be sure to tighten drain plug securely.
4) Fill cooling system. Refer to “COOLANT” and steps 8) to 10) of
“COOLING SYSTEM FLUSH AND REFILL” in this section.
COOLING WATER PIPES OR HOSES
REMOVAL
1) Drain cooling system.
2) To remove these pipes or hoses, loosen clamp on each hose
and pull hose end off.
INSTALLATION
Install removed parts in reverse order of removal procedure, noting
the following.
D Tighten each clamp securely.
D Refill cooling system with proper coolant, referring to description
on “COOLANT” and steps 8) to 10) of “COOLING SYSTEM
FLUSH AND REFILL” in this section.
To Next Page
Loading...
Need help?
General
