13.
T
ap “Exit” button, and the screen changes to “Message-
Box” screen.
14.
To reflect the created Surface to currently setting Surface,
tap ENTER button.
REMARK
On this screen, even if you tap ENTER button, the setting
will not be completed.
15.
The screen changes to the editing screen of Surface. Tap
ENTER button.
The creation of Surface is completed.
16.
Tap RETURN button on the editing screen of Surface, and
the creation of Surface is canceled.
CROWN ROAD SURF
ACE
Highlight “Crown road surface” in the Surface type, and tap
“Next>” button.
You can create the Crown road surface.
(1) Direction
(2) Length
(3) Center line
(4) Width of road
(5) Main-fall
(6) Cross-fall
CONTROL BOX SETTING
7-36
To Next Page
Loading...
Need help?
General
