METHOD FOR SWITCHING TO SEMI-AUTO MODE
Semi-auto mode is valid only after the calibration is completed.
For calibration, see
“OUTLINE OF CALIBRATION (7-150)”.
1.
Check that the engine is started.
2.
Move the machine to a gentle slopes or level ground if the machine is on a steep slopes.
3.
Check that neither the action level display (1) nor caution
lamp (2) is displayed on the machine monitor
.
4.
Check with the machine monitor that the working mode is
any of P, E, ATT/P, and ATT/E mode.
5.
Check that the control box has been started normally.
Also, check that no warning message is displayed on the
control box.
SEMI-AUTO MODE EXECUTIONS
8-6
To Next Page
Loading...
Need help?
General
