8.
Select
each item according to the specifications of GNSS
radio device and the radio setting of the base station, and
tap “Next>” button.
9.
After “Complete” screen is displayed, tap “Exit” button.
The setting is saved.
METHOD FOR SETTING GNSS RADIO CONFIGURATION
Configure the GNSS Radio according to the following procedure. As long as the configuration of the base sta-
tion is not changed, resetting is not needed.
REMARK
There are 2 specifications for the radio device, “Topcon Digital 2 (UHF)” and “Topcon FH915 (SS)”. Selection of
specifications for the radio device depends on the built-in radio board of GNSS receiver.
If the radio device of which specification is different from the one of the base station is used, the communication
is not possible. At that time, either the base station or built-in radio board of GNSS receiver must be replaced.
Contact your Komatsu distributor.
Tap “Configure” button. When “Configure” button is tapped, the
setting screen of GNSS Radio is displayed.
CONTROL BOX SETTING
7-148
To Next Page
Loading...
Need help?
General
