For the method to reset, see “METHOD FOR DISPLAYING GNSS RECEIVER INFORMATION”.
4.
If there is no abnormality or if the message is not cleared after waiting a while after step 3 has been per-
formed,
check if connectors at the both ends of cables (3) and (4) shown in the following figure are connect-
ed securely.
մ
ճ
ձղ
76
7LOWVHQVRU
5DGLR
PRGHP
0DLQ*166
$QWHQQD
0&5
&RQQHFWRU%&RQQHFWRU$
6XE*166
$QWHQQD
6LWHOLQN
PRGHP
,&7VHQVRU
&RQWUROOHU
&\OLQGHUVWURNHUHVHW
VHQVRU
,08VHQVRU
6WURNHVHQVLQJK\GUDXOLF
F\OLQGHU
*166
UHFHLYHU
&RQWUROER[
$-'
If the cables have no trouble, modem of GNSS radio device or GNSS receiver may have a trouble.
Check
if the failure code is not displayed on machine monitor, and then ask your Komatsu distributor for an
investigation of the cause and repair of it.
ACTION FOR Waiting to initialize
Phenomena: Bucket edge accuracy is bad.
In this condition, the intelligent Machine Control does not func-
tion correctly.
1.
Check if there is an obstacle around GNSS antenna (tall
building,
tree, wall, etc. which disturbs communication or
reflects radio wave).
If there is an obstacle, move to the place with no obstacle,
and wait for a while. (approximately for 15 to 20 minutes)
2.
If the message is not cleared after waiting a while, check
that the connectors at the both ends of cables (1) and (2)
are connected securely.
մ
ճ
ձղ
76
7LOWVHQVRU
5DGLR
PRGHP
0DLQ*166
$QWHQQD
0&5
&RQQHFWRU%&RQQHFWRU$
6XE*166
$QWHQQD
6LWHOLQN
PRGHP
,&7VHQVRU
&RQWUROOHU
&\OLQGHUVWURNHUHVHW
VHQVRU
,08VHQVRU
6WURNHVHQVLQJK\GUDXOLF
F\OLQGHU
*166
UHFHLYHU
&RQWUROER[
$-'
OPERATION TROUBLES AND ACTIONS
3-79
To Next Page
Loading...
Need help?
General
