16 - 6 BeneVision N Series Patient Monitor Operator’s Manual
2. Set Interval. Selecting Manual switches to manual mode.
16.8.4 Selecting NIBP Start Mode
Start mode defines how NIBP auto mode works. To set the start mode, follow this procedure:
1. Select the NIBP numeric area to enter the NIBP menu.
2. Set Start Mode.
â—† Clock: after the first measurement, the monitor automatically synchronizes NIBP automatic
measurements with the real time clock. For example, if Interval is set to 20 min, and you start NIBP
auto measurement at 14: 03, the next measurement will be taken at 14: 20, and then at 14:40, 15:00,
and so on.
â—† Interval: after the first measurement, the monitor automatically repeats measurements at set interval.
For example, if Interval is set to 20 min, and you start NIBP auto measurement at 14:03, the next
measurement will be taken at 14:23, and then at 14:43, 15:03, and so on.
16.8.5 Enabling the NIBP End Tone
The monitor can issue a reminder tone at the completion of NIBP measurement. The NIBP End Tone is off by
default. To switch on the NIBP end tone, follow this procedure:
1. Select the NIBP numeric area to enter the NIBP menu.
2. Switch on NIBP End Tone.
16.8.6 Setting NIBP Sequence
NIBP sequence measurement can have up to five phases: A, B, C, D, and E. You can individually set the duration
and interval of each phase.
To set NIBP sequence, follow this procedure:
1. Select the NIBP numeric area to enter the NIBP menu.
2. Select the Sequence tab.
3. Set Duration and Interval of each phase.
16.8.7 Setting the NIBP Display Format
To set the NIBP display format, follow this procedure:
1. Select the NIBP numeric area to enter the NIBP menu.
2. Select the Setup tab.
3. Set Display Format.
16.8.8 Setting the NIBP Alarm Limits Display Switch
To set whether to display the alarm limits of diastolic NIBP and mean NIBP, follow this procedure:
1. Select the NIBP numeric area to enter the NIBP menu.
2. Select the Setup tab.
3. Switch on or off Display Alarm Limits.
16.8.9 Showing/Hiding PR
You can set whether to display the PR value in the NIBP parameter area. To do so, follow this procedure:
1. Select the NIBP numeric area to enter the NIBP menu..
2. Select the Setup tab.
3. Switch on or off Display PR.
To Next Page
Loading...
Need help?
General
