37 - 2 BeneVision N Series Patient Monitor Operator’s Manual
37.2.3 Setting the End Case Report
To set the end case report, follow this procedure:
1. Select the Main Menu quick key → from the Report column select End Case Report.
2. From the Report Setup page, set the following end case reports:
â—† Select the Tabular Trends Report, Graphic Trends Report, Realtime Report, and ECG Report tab,
and set these end case report by referring to section 37.6Setting Reports.
â—† Select the Event Report tab, and select the event that needs to be printed.
â—† Select the 12-Lead Interpretation tab, and set the switch of Median Complex, Measurements,
Interpretation, or Interpretation Summary. For other settings, refer to section 37.6Setting Reports.
37.2.4 Setting the End Case Report Period
To set the end case report print period, follow this procedure:
1. Select the Main Menu quick key → from the Report column select End Case Report.
2. From the Select Reports page, set the Period.
• End case report print period is calculated from the patient discharged time to the configured period.
• Period setting is applicable to all of the end case report.
37.3 Manually Starting a Printing Task
You can start a printing task manually.
37.3.1 Starting Printing from the Current Page
From the current page, select the button, if available, to start printing.
37.3.2 Printing Realtime Reports
Select the Print quick key to print a realtime report. You can also print a realtime report from the Report Setup
page. For more information, see 37.3.3Printing Normal Reports.
37.3.3 Printing Normal Reports
Normal reports refers to the following types of reports:
â– ECG Report
â– Realtime Report
â– Tabular Trends Report
â– Graphic Trend Report.
To print normal reports, follow this procedure:
1. Select the Main Menu quick key →from the Report column select Report Setup.
2. Select the desired report tab.
3. Check the settings.
4. Select Print.
37.4 Automatically Printing Reports
When a parameter alarm switch is set to on and an alarm is triggered for this parameter, you can set a printer to
start alarm printing automatically.
To do so, follow this procedure:
To Next Page
Loading...
Need help?
General
