39 - 18 BeneVision N Series Patient Monitor Operator’s Manual
39.17.6 The Device Discover Tab
Multicast helps device discovery between monitors and between monitors and CMS. Devices in the same
multicast group can be mutually discovered.
39.17.7 The QoS Tab
39.17.8 The ADT Tab
The ADT (admit-discharge-transfer) gateway is normally deployed in the eGateway. You can obtain patient
information from the hospital ADT server through the ADT gateway.
39.17.9 The HL7 Configuration Tab
You can send the realtime data, waveforms, and alarms from the monitor to the hospital servers via HL7
protocol. This page also display the server connection status.
Add Central Station / Inputs the name, department, and server address
of the CMS. You can add up to 30 CMSs for your
monitor.
Menu Item Default Setting Function
Menu Item Default Setting Description
Multicast TTL 1 /
Multicast Address 225.0.0.8
Master Server Address 0.0.0.0 /
Master Server IP Address 0.0.0.0
Connected Status Disconnected
Menu Item Default Setting Description
QoS Level For Realime Monitoring 0 Selects the service quality of network connection
for realtime monitoring, for example parameter
measurements and waveforms, alarms, and so on
QoS Level For Others 0 Selects the service quality of network connection
for non-realtime monitoring, for example history
data, printing, and as on.
Menu Item Default Setting Description
Server Address 192.168.0.100 Input the host name or IP address of the ADT
gateway.
IP Address 192.168.0.100
Port 3502 Input the port of the ADT gateway.
ADT Query Off Selects whether patient information can be
loaded to the monitor from the ADT server.
Network Test / Tests whether the ADT server is properly
connected.
To Next Page
Loading...
Need help?
General
