To Next Page

To Previous Page

BeneVision N Series Patient Monitor Operator’s Manual 3 - 13

NOTE

• If you set Brightness to Auto, screen brightness automatically changes with ambient light level.

3.8.4 Adjusting the Volume

Select the Volume quick key to set Alarm Volume, QRS Volume, and Key Volume.

3.9 Starting Monitoring a Patient

After turning on your monitor, follow this procedure to monitor a patient:

1. Admit the patient.

2. Check patient settings. Make sure that alarm limits, patient category and paced status, and so on, are

appropriate for your patient. Change them if necessary.

3. Perform desired measurements. For more information, see corresponding measurement chapters.

3.10 Stopping a Parameter Measurement

To stop monitoring a parameter, follow this procedure:

1. Remove corresponding sensor from the patient.

2. Disconnect the sensor from the patient cable.

3. Disconnect the patient cable from the parameter module.

4. If you are using the disposable sensor, discard it.

3.11 General Operation

This section describes the operations that are generally used when monitoring a patient.

3.11.1 Switching On or Off a Parameter

You can also manually switch on or off a parameter when its module is connected. If setting parameter switches

is not password protected, follow this procedure to set parameter switches:

1. Access Parameters On/Off by any of the following ways:

◆ Select the Screen Setup quick key → select the Parameters On/Off tab.

◆ Select the Main Menu quick key → from the Parameters column select Parameters On/Off.

2. Enable or disable desired parameters.

If setting parameter switches is password protected, to set parameter switches, switch on Parameters On/Off

Protected. see 39.12The Other Settings.

When a parameter is switched off, the monitor stops data acquisition and alarming for this measurement.

NOTE

• When a parameter is manually switched off and the corresponding parameter module is plugged in,

you cannot monitor this parameter.

3.11.2 Displaying Parameter Numerics and Waveforms

You can configure the parameter numerics, waveforms, and their sequence displayed on the normal screen. To

do so, follow this procedure:

1. Access Tile Layout in either of the following ways:

◆ Select the Screen Setup quick key → select the Tile Layout tab.

◆ Select the Main Menu quick key → from the Display column select Tile Layout.

Mindray BeneVision N Series User Manual

Questions and Answers: