Mindray BeneVision N Series User Manual

BeneVision N Series Patient Monitor Operator’s Manual 33 - 1
33 HemoSight
TM
33.1 HemoSight
TM
Introduction
This monitor provides the HemoSight
TM
function. You can easily view and review hemodynamic parameters
through the HemoSight menu.
The HemoSight menu is available when you are using the following modules:
■ PiCCO module
■ ScvO
2
module
■ C.O. module
■ ICG module
CCO/SvO
2
module (measured from the Vigilance II, Vigileo, EV1000, and HemoSphere monitor)
For detailed information on monitoring and setting hemodynamic-related parameters, see 22Monitoring
Continuous Cardiac Output (from PiCCO Module), 19Monitoring Central Venous Oxygen Saturation (ScvO
2)
,
18Monitoring Cardiac Output (C.O.), 21Monitoring Impedance Cardiography (ICG), and 20Monitoring CCO/
SvO
2
. This chapter only introduces functions operated through the HemoSight menu.
33.2 Accessing the HemoSight Menu
Access the HemoSight menu by either of the following ways:
■ Select the HemoSight quick key.
■ Select the CCO numeric area, ScvO
2
numeric area, SvO
2
numeric area, or ICG numeric area → from the
bottom of the pop-up menu select HemoSight.
■ Select the Main Menu quick key → from the CAA column select HemoSight.
33.3 Viewing Hemodynamic Parameters
To view hemodynamic parameters, select the desired tab on the Diagnosis page of the HemoSight menu:
◆ Select All to view all hemodynamic parameters. For more information, see 32.2.1 Hemodynamic
Parameters.
◆ Select Physiology Graphics to view dynamic graphics for parameters’ changes. For more
information, see 33.3.2Physiology Graphics.
◆ Select Physiology Relationship to view the realtime relationship of parameters. For more
information, see 33.3.3Physiology Relationship.
◆ Select Decision Model to view measured values and targeted values. The Decision Model page is
only available for the PiCCO module. For more information, see 33.3.4Decision Model (Only Available
for PiCCO Module).
The symbols beside the hemodynamic parameters have the following meanings:
■ *: indicates an intermittent parameter.
■ **: indicates an oxygenation parameter.
■ *Measure Time: refers to the measurement time of the intermittent parameter.
■ ↑ or ↓: indicates that a parameter value exceeds its upper or lower limit.

Mindray BeneVision N Series Specifications

General

Brand	Mindray
Model	BeneVision N Series
Category	Medical Equipment
Language	English