BeneVision N Series Patient Monitor Operator’s Manual 28 - 5
28.6 Preparing for BIS Monitoring
To perform BIS monitoring, follow this procedure:
1. Connect the BISx or BISx4 to the BIS module.
2. Use the attachment clip to secure the BISx or BISx4 to a convenient location near the patient’s head.
3. Connect the BISx or BISx4 to the patient cable.
4. Attach the BIS sensor to the patient following the instructions supplied with the sensor.
5. Insert the BIS sensor into the patient cable connector until it is fully engaged.
6. Observe the results of the automatic sensor check in the numeric area.
Sensor Check is initiated automatically when the BIS sensor and the patient cable are connected to the BISx or
BISx4. The measurement starts automatically after the sensor has passed the check.
• To minimize the risk of patient strangulation, the patient cable must be carefully placed and secured.
• Make sure the patient’s skin is dry. A wet sensor or a salt bridge could result in erroneous BIS and
impedance values.
• Do not use if sensor is dry. To avoid dry out, do not open pack until ready for use.
• Due to intimate skin contact, reuse may pose risk of infection. If skin rash or other unusual symptom
develops, stop using and remove.
(1) BIS module (2) BISx or BISx4
(3) Patient cable (4) BIS sensor
To Next Page
Loading...
Need help?
General
