9
03.04 "Startup" Operating Area
9.3 NC
9
Ó Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition 9-447
9.3 NC
Start-up
key
Setting a key position for the startup switch with appropriate access
rights.
NCK
addresses
View and edit the NCU/CCU address.
It is normally only necessary to edit the address for M : N operation.
You cannot undo an address change with general reset. The address
change is not saved in an NC series startup archive.
9.4 PLC
· Changes can only be made to the PLC operands with the
appropriate password.
· The procedure for handling PLC operands is described in
subsection "PLC" in Chapter 8, "Diagnosis" Operating Area.
Danger
Changes in the states of PLC memory locations have a major impact
on the machine. Incorrect parameterization may endanger human life
and cause damage to the machine.
9.4.1 PLC status
See Chapter 8, "PLC Status".
To Next Page
Loading...
Need help?
General
